Food Equipment Commercial Oven Repair Combi Oven Repair Dishwasher Repair Deep Fryer Repair Char Grill & Flat Top Repair All Food Equipment Services Refrigeration & Cool Rooms Cool Room Repair Gas Appliance Repair Electrical Repairs Air Conditioning Service Areas All Perth Metro & WA General News FAQ Who We Serve Why PEMS Existing Job Update Contact 📞 24/7 — 08 9554 3123 Book a Service 24/7
Equipment Repair -- Perth WA

Commercial Cool Room Repair Perth

PEMS diagnoses and repairs commercial cool rooms for hospitality venues, food retailers, and industrial operators across the Perth metro area.

Commercial cool rooms fail for a range of reasons -- door seal degradation, refrigerant leaks, compressor faults, and evaporator icing are among the most common -- and when they do, perishable stock is immediately at risk. Hospitality operators, supermarkets, butchers, and food manufacturers depend on these systems running within tight temperature bands around the clock. A technician without refrigeration licensing and hands-on cool room experience will cost you time and product; PEMS holds ARC refrigeration accreditation AU59251 and has completed 11 cool room jobs across Perth.

Common Commercial Cool Room Faults PEMS Repairs

Temperature Not Holding

This is typically caused by low refrigerant charge, a failing compressor, or a blocked condenser coil reducing heat rejection capacity. PEMS pressure-tests the refrigeration circuit, checks superheat and subcooling, and restores correct refrigerant levels or replaces the compressor under ARC-compliant procedures.

Evaporator Icing Over

Ice build-up on the evaporator coil blocks airflow and causes the room temperature to rise steadily, often pointing to a defrost control failure, faulty defrost heater, or a sensor reading incorrectly. PEMS tests the defrost board and components, replaces defective parts, and manually defrosts the coil to restore normal airflow.

Door Seals and Gasket Failure

Worn or torn door gaskets allow warm, humid air into the cool room, increasing compressor run time, raising energy costs, and causing condensation and icing issues inside the cabinet. PEMS inspects door alignment, hinge condition, and gasket integrity, supplying and fitting replacement seals to restore a proper thermal barrier.

Compressor Not Starting or Short-Cycling

A compressor that trips on overload or short-cycles is often responding to high discharge pressure, a failed start capacitor, or electrical supply issues at the condensing unit. PEMS carries out electrical testing at the condensing unit, checks capacitors and contactors, and identifies whether the fault is electrical or refrigerant-side before recommending repair or replacement.

Why PEMS

PEMS holds ARC refrigeration accreditation AU59251, a Type A Gas licence, and electrical contractor licence EC016553 -- covering all three trades involved in commercial cool room work without subcontracting any part of the job. That matters for facility managers who need a single accountable contractor for compressor, electrical, and gas-side faults. With 11 commercial cool room jobs completed across Perth, PEMS carries the diagnostic experience to work on walk-in cool rooms, remote condensing systems, and built-in refrigerated rooms in commercial kitchens. Call 08 9554 3123 to discuss your fault or book a site inspection.

PEMS services commercial cool rooms across the Perth metro area and surrounds, including the CBD, Fremantle, Joondalup, Mandurah, Rockingham, and the Perth Hills.

Call for Cool Room Repair

Or call 08 9554 3123

LinkedIn